Vertically Printable Evanescent Mode Filters

Lucas Polo-López (1) , Stefano Sirci (2) , Antoine Calleau (2) , Santiago Capdevila (2) , Giovanni Toso (3) , Esteban Menargues (2) , Maria Garcia-Vigueras (1)

1 IETR - Institut d'Électronique et des Technologies du numéRique
2 SWISSto12
3 ESA - ESTEC (Netherlands)

This work presents a new topology of evanescent mode filter (EMF) that allows for its efficient additive manufacturing (AM). Chamfered ridges which avoid the appearance of undesired supports when printed vertically (i.e., along the propagation axis of the filter) are considered. This strategy ensures accurate tolerances, reduced cost and it also enables monolithic manufacturing of the EMF as part of a feed chain. A circuit model is developed to explain the behavior of the new ridges as well as to speed up the overall filter design. The proposed concept and methodology are validated experimentally through the manufacturing and measurement of a prototype.

Mots clés: Integrated circuit modeling; Resonators; Topology; Impedance; Load modeling; Behavioral sciences; Manufacturing; 3-D-printing; additive manufacturing (AM); equivalent circuits; evanescent mode filters (EMFs); microwave filters

Domaines: Sciences de l'ingénieur [physics]

Lucas Polo-López, Stefano Sirci, Antoine Calleau, Santiago Capdevila, Giovanni Toso, et al.. Vertically Printable Evanescent Mode Filters. IEEE Microwave and Wireless Components Letters, 2022, 32 (11), pp.1299-1302. ⟨10.1109/LMWC.2022.3187781⟩. ⟨hal-03771485⟩