Tungsten-based cost-effective gas sensors for h2 s detection

D. Fasquelle (1) , N. Verbrugghe (1) , Stephanie Deputier (2)

1 UDSMM - Unité de Dynamique et Structure des Matériaux Moléculaires
2 ISCR - Institut des Sciences Chimiques de Rennes

Tungsten trioxide thin films were deposited on silicon substrates by non-reactive RF sputtering from a WO3 target at room temperature. The WO3 films were post-annealed at two different temperatures, 400◦ C and 500◦ C. The morphological and microstructural properties of these films were analyzed by using atomic force microscopy and X-ray diffraction. X-ray diffraction patterns only show WO3 oxide phases. The AFM images show different morphologies with smaller grains for the film annealed at 400◦ C. WO3 sensing films and W heating elements were embedded in commercial cases for the fabrication of cost-effective gas sensors. The sensitivity and dynamic response of the sensors were analyzed under various concentrations of H2 S, from 20 to 100 ppm, at SIMTRONICS SAS (3M Company, Saint Paul, MN, USA). A good sensitivity G/G0 of about 6.6 under H2 S 100 ppm was obtained with the best sensor. An interesting dynamic response was observed in particular with a short response time. Additionally, the evolution of the sensitivity was studied, and a conduction model was proposed for explaining the conduction mechanism under H2 S exposition. © 2021 by the authors. Licensee MDPI, Basel, Switzerland.

Mots clés: Gas sensor; Hydrogen sulfide; RF sputtering; WO3 thin film

Domaines: Chimie

D. Fasquelle, N. Verbrugghe, Stephanie Deputier. Tungsten-based cost-effective gas sensors for h2 s detection. Chemosensors, 2021, 9 (11), pp.295. ⟨10.3390/chemosensors9110295⟩. ⟨hal-03468835⟩