Adaptive NoC for reconfigurable SoC - Université de Rennes Accéder directement au contenu
Thèse Année : 2013

Adaptive NoC for reconfigurable SoC

NoC adaptatif pour SoC reconfigurable

Résumé

Chips will be designed with billions of transistors and heterogeneous components integrated to provide full functionality of a current application for embedded system. These applications also require highly parallel and flexible communicating architecture through a regular interconnection network. The emerging solution that can fulfill this requirement is Network-on-Chips (NoCs). Designing an ideal NoC with high throughput, low latency, minimum using resources, minimum power consumption and small area size are very time consuming. Each application required different levels of QoS such as minimum level throughput delay and jitter. In this thesis, firstly, we proposed an evaluation of the impact of design parameters on performance of NoC. We evaluate the impact of NoC design parameters on the performances of an adaptive NoCs. The objective is to evaluate how big the impact of upgrading the value on performances. The result shows the accuracy of choosing and adjusting the network parameters can avoid performance degradation. It can be considered as the control mechanism in an adaptive NoC to avoid the degradation of QoS NoC. The use of deep sub-micron technology in embedded system and its variability process cause Single Event Upsets (SEU) and ''aging'' the circuit. SEU and aging of circuit is the major problem that cause the failure on transmitting the packet in a NoC. Implementing fault-tolerant routing techniques in NoC switching instead of adding virtual channel is the best solution to avoid the fault in NoC. Communication performance of a NoC is depends heavily on the routing algorithm. An adaptive routing algorithm such as fault-tolerant has been proposed for deadlock avoidance and load balancing. This thesis proposed a novel adaptive fault-tolerant routing algorithm for 2D mesh called Gradient and for 3D mesh called Diagonal. Both algorithms consider sequences of alternative paths for packets when the main path fails. The proposed algorithm tolerates faults in worst condition traffic in NoCs. The number of hops, the number of alternative paths, latency and throughput in faulty network are determined and compared with other 2D mesh routing algorithms. Finally, we implemented Gradient routing algorithm into FPGA. All these work were validated and characterized through simulation and implemented into FPGA. The results provide the comparison performance between proposed method with existing related method using some scenarios.
Les systèmes embarqués sur puce modernes intègrent des milliards de transistors et des composants intégrés hétérogènes pour fournir toutes les fonctionnalités requises par les applications courantes. La solution support de la communication dans ce cadre s'appuie sur la notion de réseau sur puce (NoC pour network on chip). Les principaux objectifs de la conception d'un NoC sont d'obtenir des performances élevées, pour un coût d'implémentation (notamment en surface et en consommation électrique) le plus faible possible. Ainsi, le concepteur de NoC doit tenir compte de l'impact des paramètres du NoC sur le compromis entre les performances du réseau et la taille de silicium requis pour son implémentation. L'utilisation de la technologie submicronique profonde amène des phénomènes de variabilité et de vieillissement qui causes des événements singuliers uniques (SEU pour Single Event Upset). Un SEU provoque le changement d'état d'un bit qui provoque l'échec de la transmission d'une donnée dans un NoC. La mise en œuvre de routage supportant la tolérance aux fautes est donc nécessaire. Dans cette thèse, nous proposons dans un premier temps, une évaluation de l'impact des paramètres de conception des NoC sur ses performances. Le résultat permet de guider le concepteur dans ses choix et le réglage des paramètres du réseau permettant d'éviter la dégradation de ses performances. Deuxièmement, nous avons proposé de nouveaux algorithmes de routage adaptatifs tolérants aux pannes pour un réseaux maillé 2D appelé Gradient et pour un réseaux maillé 3D appelé Diagonal. Ces algorithmes s'adaptent et proposent des séquences de chemins alternatifs pour les paquets lorsque le chemin principal est fautif. Nous avons ainsi évalué le coût d'implémentation de Gradient sur un FPGA actuel. Tous ces travaux ont été validés et caractérisée par simulation et mis en œuvre en FPGA. Les résultats fournissent la comparaison des performances de nos algorithmes avec les algorithmes de l'état de l'art.
Fichier principal
Vignette du fichier
PRATOMO_Istas.pdf (3.29 Mo) Télécharger le fichier
Origine : Version validée par le jury (STAR)
Loading...

Dates et versions

tel-00980066 , version 1 (17-04-2014)

Identifiants

  • HAL Id : tel-00980066 , version 1

Citer

Istas Pratomo. Adaptive NoC for reconfigurable SoC. Other. Université de Rennes; Université européenne de Bretagne (2007-2016), 2013. English. ⟨NNT : 2013REN1S136⟩. ⟨tel-00980066⟩
332 Consultations
972 Téléchargements

Partager

Gmail Facebook X LinkedIn More